Remove screws as in circles and arrows 800x600 |
We need to remove the rainsheet. Remove the 5 screws... 800x600 |
Rainsheet removed.. Did you notice the bitumen strips?? There are some rainsheet black sticky stuff too.. 800x600 |
Bitumen strips removed by bare-hand-peeling and sticky stuff removed too... 800x600 |
Put down the window glass until the screw position same as the hole as in picture... Remove them to release the glass.. 800x600 |
Remove the glass from the door follow the path in ordered numbers... 600x800 |
Place it somewhere safe. I place it on my car roof on a piece of Insulflex. 800x600 |
Now we remove the entire power window bracket and motor construction. Remove those 10mm bolts as in circles. 800x600 |
Power window bracket n stuff comes out this way... 800x600 |
Motor replaced.. Simple job. U may need to change the rubber bush as well.. Sorry, I forgot to take picture when it is dismantled.. :p 800x600 |
OK. Now put back into position.. 800x600 |
Once done.. project dynamatt begins.. Lots of holes need to cut for mounting screws and holes.. This is completed right door. 800x600 |
This is left side door.. Cleaned n ready for dynamatt... 800x600 |
Left door done... (1st time job - not bad huh??) 800x600 |
The actual size of dynamatt... Was trying to soften it with the sunlight.. but i find it easier to peel off the brown paper without soften it.. I used hot air gun to soften it after i fully stick it on the door... 800x600 |
If you are wondering what's inside my door... this is the answer (Black - SoundBlok Suppresion pads, Shiny - bitumen strips) 800x600 |
This is my idea to protect the midbass speakers from getting in contact with rain water. I think this will reduce the bass a little... We'll see how it goes... 800x600 |
| |
