Rear Anti-Roll Bar (ARB) from Wira 1.6

31st May 2005

This is a complete ARB kit took from wira 1.6 which includes the bar itself, armlinks, and the lower arms...

However, during installation... the armlinks are already worn-out. So i decided to replace with new ones to avoid problems later. The instalation is kinda expensive due to the algnment labourcharge.

Overall, i'm very satisfied with the performance when taking corners. When slow (around 40kmh), almost no bodyroll and when fast... bodyroll is minimal... the feel is good n very confident when taking corners... even changing lanes... 2 thumbs up!!

Half-cut rear ARB with real "half-cut" lower arms 640x401	additional lower arms provided since those connected arms are cut 640x480	left armlink with bracket 480x640
right armlink with bracket - rusty 480x640	ARB dismantled.. cleaned and resprayed 640x480	lower arms not sprayed.. just cleaned with thinner 640x480
mechanic working on my car... 640x480	working fast.. but very rough handling on those tools.. 640x480	Everything properly installed.. 640x480
You can see the bracket, bar, armlink n ower arm 640x480	ARB to the left 640x480	Right side 640x480
Left side 640x480	mounting bracket.. just plug and play 768x1024	Wira 1.5 lower-arms (without ARB bracket) 640x480
Wira 1.5 lower-arms (without ARB bracket) 640x480